Description
BIGTREETECH Motherboard Manta M4P
BIGTREETECH CB1 is an alternative to Raspberry Pi CM4. BIGTREETECH M4P is a 4-axis motherboard using a CM4 BTB header which can work with CB1 or CM4 perfectly.
Original price was: $ 66.98.$ 47.84Current price is: $ 47.84.
BIGTREETECH Motherboard Manta M4P
50 in stock
BIGTREETECH Motherboard Manta M4P
BIGTREETECH CB1 is an alternative to Raspberry Pi CM4. BIGTREETECH M4P is a 4-axis motherboard using a CM4 BTB header which can work with CB1 or CM4 perfectly.
BIGTREETECH MANTA M8P is a 32-bit printer motherboard developed by the 3D printing team of Shenzhen Big Tree Technology Co. Ltd. for Klipper firmware. You can simply plug in the core board to run the Klipper firmware which greatly simplifies the connection between the motherboard and the Raspberry Pi and saves a lot of space. Moreover the BTB connector is designed to install CM4 or other solutions to solve the current expensive problem of CM4.
2. M4P Main Features
1. DSI1 CSI1 interface (for CM4)
1. Adopt 32-bit 64MHz ARM Cortex-M0+ series STM32G0B1VET6 as the main control chip;
2. The power chip TPS5450-5A supports DC12/24V power input. The output current of the chip is up to 5A and the peak value can reach 6A which perfectly supports the power supply of Raspberry Pi;
3. There is a BOOT button reserved on the motherboard users can update the bootloader through DFU;
4. The thermistor part includes a protection circuit that protects the main control chip from the possibility of burning caused by leakage of the heated bed or heater cartridge;
5. 24V 12V and 5V voltages are available for CNC fans eliminating the need for an external transformer module thereby reducing the chance of damage to the motherboard due to improper operation;
6. The thermistor can select the pull-up resistor value through the jumper in this way it supports PT1000 without an external module which is convenient for customers to DIY;
7. The MCU firmware can be updated via an SD card or through Klipper’s make flash command using DFU;
8. The motherboard and the core board use the BTB connection to allow using other solutions other than CM4;
9. On-board TMC-driver SPI and UART working modes on-board DIAG function pins can be used by simply plugging and unplugging the jumper cap;
10. Support filament runout detection auto shutdown BLTouch RGB lights…
11. High efficiency MOSFET for less heat generation;
12. Adopt replaceable fuse for easy replacement;
13. Three-way four-wire fan interface is reserved and can be used to connect the water cooling device;
14. The proximity switch interface is reserved supports NPN and PNP types (24V 12V 5V) voltage selection is available common voltage selection with VFAN6;
15. Provide the SPI expansion interface to allow Klipper firmware users to connect an external acceleration sensor for acceleration compensation.
“
Reviews
There are no reviews yet.