Thank you for purchasing MOTIVE-RC’s S-FHSS compatible receiver. This production can supply enhancement smooth drive with FUTABA S-FHSS link.
Compatibility:
MOTIVE-RC 2.4GHz S-FHSS Compatible Receiver is designed to use with FUTABA S-FHSS 2.4GHz transmitters such as surface system T3PV 4PLS T4PX T4GRS T4PM T4PV T7PX T10PX or air system T4YF T6J T6K T8J T10J T14SG T18MZ T18SZ under S-FHSS protocol mode.
Feature:
4ch servo channels on CH1~CH4
S.BUS output support expanding servo channels on the 5th channel.
Normal mode and High Speed mode.
Support Fail-safe function on all channels
Specifications:
Model Type: RC Car/Boat
Operating Current: 40mA max and 20mA under linked
Antenna: Built-in PCB onboard antenna
Operating Voltage: 3.6~8.5V
Operation temperature: – 10~70 degC
Weight: 5g
Size: 26x22x17.3 mm
Latency: 13.6mS(High Speed mode) or 20.4mS(Normal mode)
Bind procedure:
1. Insert the bind cable into the receivers “BIND”channel plug the power cable into any other channel.
2. Turn on the S-FHSS transmitter leave it 0.5M~1M away the receiver.
3. Red LED light on and Green LED off when searching signals and turn to Green LED light on and Red LED off indicate bind is succeeded.
4. Remove the power and bind cables from the receiver reconnect the power cable to the receiver.
5. Check to make sure that the transmitter and receiver are working as expected if there are any issues or unexpected operation follow the steps above to bind again.
Fail-safe setting:
MR4SB set failsafe on the S-FHSS transmitter just like the operation of the FUTABA receivers if the feature exist. We highly recommend you set failsafe feature while driving your models. An example of a useful failsafe setting would be to shut down the model’s throttle so that it does not drive away uncontrolled.
High Speed/ Normal mode switch guide:
If your receiver has been linked with your transmitter please power off your transmitter. When your receiver’s LED light red Insert the bind cable into the receivers “BIND”channel for more than 6 seconds and no more than 10 seconds then remove the bind cable and see the green LED flashing. Now insert the bind cable again and the receiver turns back to light red. Now the mode status has switched between high-speed mode and normal mode. When the green and red LED ON it means that the normal mode is switched to high-speed mode and when the green LED flashes quickly it means that the high-speed mode is switched to normal mode.
Note: If you want to reset the receiver to normal mode you can rebind the receiver to the remote control.
Reviews
There are no reviews yet.