Wireless Head Tracker Module First Perspective Control Transmitter Receiver Tracking Sensor for RC Airplane FPV Drone Gimbal

• Description
• Reviews (0)

Wireless Head Tracker Module First Perspective Control Transmitter Receiver Tracking Sensor for RC Airplane FPV Drone Gimbal

Specification:

– Item name:head tracker module

– Transmitter air control distance:＞800m

– Transmitter ground control distance:＜200m

– Transmitter built-in power:3.7V 300mAh

– Transmitter size:56mm x 30mm x 15mm

– Receiver size:35mm x 20mm

– Shell size:45.5mm x 25mm

– Receiver input voltage:DC 5V

– Used for FPV drone rc airplane

Feature:

– Adopt independent RC wireless communication

– High-precision sensor is adopted with accurate action collection and low drift

– Adopt independent RF remote communication technology

– The transmitter does not need wiring and does not occupy the remote control channel.

Usage:

1.Power on/off Transmitter:

Short press the “on/off button” once and then long press the “on/off button”.

2.Binding:

– Step 1. Power off the transmitter and receiver

– Step 2. Long press and hold on the “binding button” of the receiver and at the same time power on the receiver by connecting the battery to it.

Blue light flashes fast – binding starts.

– Step 3: Long press and hold the “PITCH+ button” on the transmitter at the same time short press once and then long press the “ON/OFF button”.

There is a beep sound which means that the binding is successful.

3.Receiver Wire Connection:

– CH1: idle output voltage is equal to the input voltage

– CH2: YAW channel to connect left-right direction servo

– CH3: PITCH channel to connect pitching direction servo

– CH4: power input 5-12V(Left:signal; Middle:battery positive pole; Right:battery negative pole)

– The yellow signal cable of the servo connected to the CH2 and CH3 need to plug into the left side.

4.Gimbal Back to Center:

To double press the “ON/OFF button” then it will make a beep sound.

5.Reverse Servo Direction:

– Left-right direction: long press and hold the “YAW+ button” and “YAW- button” on the transmitter till it emits a beep sound.

– Pitching direction: long press and hold the “PITCH+ button” and “PITCH- button” on the transmitter till it emits a beep sound.

6.Calibration and fine adjusting:

– Short press the “ON/OFF button” twice and there will be 3 beep sound and the gimble will be reset and it will be back to the middle point.

– To fine adjust the servo:

Long press the “ON/OFF button” and it emits 3 beep sound and then press “+” or “-” of YAW and PITCH botton to do fine adjusting of the servo.

Long press the “ON/OFF button” to quit the setting mode.

7.Adjust the Rudder Quantity:

Press the corresponding “+” “-” button of servo.

Note:

1.The gimbal and others will not include.

2.Due to manual measurement the size may have slightly deviation.

3.If you are using a 5V servo and want to use 12V to power the head tracker and receiver you need to use buck module otherwise the servo will burn out.

Package include:

1set x kit no shell

or

1set x kit with shell

If you need gimbal with servo please click below picture.

Reviews

There are no reviews yet.

Be the first to review “Wireless Head Tracker Module First Perspective Control Transmitter Receiver Tracking Sensor for RC Airplane FPV Drone Gimbal” Cancel reply

Your email address will not be published. Required fields are marked *

Your rating * Rate… Perfect Good Average Not that bad Very poor

Your review *

Name *

Email *

Save my name, email, and website in this browser for the next time I comment.

 Yes, add me to your mailing list

Δ